Welcome Home...THANK YOU FOR BEING A PART OF OUR COMMUNITY

I love moras. But I was curious what others thought about them.

Views: 7029

Replies to This Discussion

Mora of Sweden Exclusive 

Vintage KJ Eriksson Classic

Pontus Holmberg Eskilstuna, Sweden

Eric Frost Scout Knife

Vintage Frosts Model #54 Fillet Knife

KJ Eriksson Hunter

Swedish Scandis Top to bottom:

Frosts Rostfri Med Skarpa

Stalvaru A-B

Broderna Jonsson

Guttman Cutlerly (Frosts) distributor

Broderna Jonsson

Eric Frost

Guttman Cutlery (Frosts)

KJ Mora

KJ Eriksson

Edgemark distributor

PIC distributor

Mora Knivfabrik (old Frost mark)

One of the best to use for a neck knife (as far as with the original sheath) is the 601 with the double guard. I run a lanyard through the sheath drain hole, put a knot in the end that can be drawn into the sheath, then I knot the other end after passing through an overhand knot at the drain hole. The knife goes in the sheath either way. It's small. And, safe to use.

Doug Gerdes said:

Moras make wonderful neck knives in my opinion, you can't beat that edge, and keeping it handy at your chest saves a lot of time no matter what the task!

Thanks Ivars, I am surprised that you had a spoon carver with a double bevel. The ones I've seen are laminated blade. But, it should not be visible. If a laminated blade  is not sharpened with the stone laying flat, the stone can cut away the harder steel, leaving a secondary bevel, which would be at a different angle than the intended angle. More of a blunt edge in comparison to what the factory edge was. Some use a wooden dowel rod wrapped with sandpaper for sharpening.

RSS

White River Knives

Latest Activity

Visit Lee' s Cutlery

KNIFE AUCTIONS

KNIFE MAGAZINE!!!

tsaknives.com

JSR Sports!

Click to visit

© 2024   Created by Jan Carter.   Powered by

Badges  |  Report an Issue  |  Terms of Service