iKnife Collector
The online community of knife collectors, A Knife Family Forged in Steel
Ganzo
Add a Comment
-
In Memoriam Comment by D ale on June 8, 2012 at 4:38 -
... and check out the slot between the pivot hole & the spring hole. Whatever method used to blank out the blade ... wire EDM .. H2O jet .. ?? ... was not interrupted between the two. Only one entry hole that way .. I guess.
-
In Memoriam Comment by D ale on June 8, 2012 at 4:00 -
On first sight .. it looks really sweet !!!
A closer look to the inside reveals an inherent weak point in this design. The area of the blade tang clearanced for the locking pin while in the closed position .. is soooo close .. to the area of the blade tang where the stop pin strikes .......... it simply leaves too little . imo .
It wouldn't take much lateral force to cause failure .. i.e. prying would snap the blade @ the narrow spot.Looks sweet though .. & the price was right. If/when I make my own .. think I'll loose the little ears & move the stop pin back ........
whiteriverknives.com
Latest Activity
"12 degrees here in downtown Saint Thomas, PA this morning. The wind has died down, so it is no longer a brutal day."
"14 degrees and 30-40 mph winds today. A good time to work on organizing my collection."
© 2026 Created by Jan Carter.
Powered by
You need to be a member of iKnife Collector to add comments!
Join iKnife Collector