iKnife Collector
The online community of knife collectors, A Knife Family Forged in Steel
When blades cross
Most everyone knows what blade rub is. What is the technical term for when a blade crosses paths with another blade and either fails to close or closes on the wrong side of the other blade?
Replies to This Discussion
-
2021 CalendarPermalink Reply by J.J. Smith III on -
A mess...?
-
Permalink Reply by Jan Carter on
-
I hate to say I may have heard it but I dont know. So I am going with JJ's answer
-
Permalink Reply by Lee Smith on
-
I know I hate it. One of the reasons I prefer 1 and 2 bladed knives.
-
Permalink Reply by Steve Hanner on
-
Its broke
-
Permalink Reply by Tobias Gibson on
-
Okay, I've been going through my notes and I'm about 90% sure the term is drift or blade drift. It normally happens when the blade is properly pinned (too loose or too tight) or the frame is bent.
It can occur on one and two blade knives such as toothpicks, peanuts and trappers. When it does, an unbent blade actually makes contact with the side of the liners and gets hung up.
whiteriverknives.com
Latest Activity
2021 CalendarJ.J. Smith III replied to black mamba knives's discussion Anyone else noticing printed "Damascus" creeping into the collectible side of the hobby?
2021 CalendarJ.J. Smith III replied to black mamba knives's discussion Handles that keep changing after you buy them
KnifeMakerblack mamba knives replied to black mamba knives's discussion Handles that keep changing after you buy them
© 2026 Created by Jan Carter.
Powered by
