Welcome Home...THANK YOU FOR BEING A PART OF OUR COMMUNITY

I am trying to make some simple kitchen knives. I bought some Schrade factory blades at auction and I have some nice pieces of mule deer horn for the handles. I was hoping some one out there could tell me what the best glue is to use on this project

Views: 123

Reply to This

Replies to This Discussion

2 part, 5 min epoxy

I have had good luck with the 2-part 650 toughened epoxy from West System.

Takes 10 hours to fully cure, but crazy strong, shock resistant, and the next thing to waterproof.  The handle material probably soaks up more water than the epoxy.

Reply to Discussion

RSS

whiteriverknives.com

Latest Activity

Kevin D replied to db's discussion couple more modern
2 minutes ago
Kevin D replied to db's discussion couple more modern
9 minutes ago
db replied to db's discussion couple more modern
21 minutes ago
Kevin D replied to db's discussion couple more modern
40 minutes ago
db replied to db's discussion couple more modern
42 minutes ago
db replied to db's discussion couple more modern
44 minutes ago
db replied to db's discussion couple more modern
48 minutes ago
db replied to db's discussion couple more modern
51 minutes ago
db replied to db's discussion couple more modern
55 minutes ago
Kevin D commented on dead_left_knife_guy's photo
56 minutes ago
db posted a discussion
57 minutes ago
Kevin D commented on dead_left_knife_guy's photo
1 hour ago

Featured
dead_left_knife_guy posted photos
1 hour ago
Mike Bryant posted photos
6 hours ago
J.J. Smith III left a comment for Steven C Humphries
8 hours ago
J.J. Smith III left a comment for Rodney
8 hours ago

© 2025   Created by Jan Carter.   Powered by

Badges  |  Report an Issue  |  Terms of Service