Someone asked about making damascus with powdered steel. Here is a brief overview based on my knowledge and experience. This info is based on making carbon steel damascus. You can introduce small quantities of stainless to carbon steel damascus and continue to treat it (and heat-treat it just like carbon steel). Most of time you see a repeating pattern in a blade, you are seeing powder steel damascus. Often when you see bolsters with the same pattern, you are seeing powder steel damascus. Here… Continue

Someone asked me recently, what is damascus? Simply put damascus steel is what you get when you take two or more types of steel (usually), put them into a forge, bring them up to welding temp (about 2000 - 2100 degrees), pull them out and quickly hammer them together into one solid pice of steel.



Typically you will start with 5 - 10 layers of steel approx one inch wide, 3 inches long and 1/8th" thick.

They will be stacked together in alternate layers. One end of the stack will… Continue

Those of you in the early stages of knife making might find these links useful.

Good luck! Be sure to use common sense and always be very safe and cautious!



Remember: you only get two eyes, two ears, two lungs and ten fingers. Try to

make them last at least 100 years.



General knifemaking links:…

Continue