Welcome Home...THANK YOU FOR BEING A PART OF OUR COMMUNITY

Something I’ve noted (perhaps, imagined) with split back whittlers and the passing of time. The grind on the primaries used to retain more of the stout thickness inherent in the design.

 

That btm one is a Waterville.  It’s a saber spear blade grind .. and it is stout.

The Schrade in the middle was mid~late 40’s production. It’s a std spear blade grind. You still cannot tell where the tang stops & the blade grind begins .. top view anyway.

The top one is Queens current production #48. It has a clip blade grind .. no problem telling where the tang stops & the blade grind begins on that one !!!

 

I don’t get it .. have the primary be 2~3 times as thick (robust) as the secondary’s .. by design !!!

Then purposely grind it down to the flimsier thickness of the secondary’s .. right after the tang ??

 

Is this something you folks also see in your whittlers ???

What about the Warncliffe blade grind ???

Views: 300

Replies to This Discussion

The tang thickness is more to facilitate adding clearance for the secondary blades to nest and also give a  resting place for the two secondary blade springs. Back in the day, the factories where not as concerned about blades rubbing each other. On customs and higher end knives today most buyers expect no blade rub. I think that is why the Queen has more "drop" in the grind

Ken,

Thanks, that makes sense

I know what you mean about the clearance issues .. but check it out .. there aren't any !!!!

 

That Waterville on the btm is 100 yrs old and there's no wear to indicate the blades have been touching .. tolerances are tight on that one !!!

 

One can begin to see more clearance between the blades on the  Schrade in the middle.

 

That Queen should never have one blade touch another .. it just seems excessive clearance @ the loss of blade strength on the primary ?!?!?

 

I guess my question is ..... Given the fact that a whittler ..by design.. requires the primary to be ~ twice as thick as either secondary .. why waste any more of that added sturdiness addressing clearance issues than absolutely neccesary ???

 
Is the increased tolerance to more readily facilitate mass production .. perhaps ???
Clearence on my Bulldog Viking is somewhat tight.  The blades are the same size as on the Thor, in a smaller frame.  The Wharncliffe spine will push the secondaries out, at the end, if they aren't closed carefully.

Ken,

I understand exactly what you are saying and it makes sense to me but in looking at your knives last week I dont remember the gaps being as prominant as we are seeing here.  So I wonder if Dales question is very valid

Is the increased tolerance to more readily facilitate mass productions...perhaps???

RSS

White River Knives

Latest Activity

Visit Lee' s Cutlery

KNIFE AUCTIONS

KNIFE MAGAZINE!!!

tsaknives.com

JSR Sports!

Click to visit

© 2024   Created by Jan Carter.   Powered by

Badges  |  Report an Issue  |  Terms of Service