iKnife Collector
The online community of knife collectors, A Knife Family Forged in Steel
TIP: How to Clean Up Solder and Glue
Here is a good way to scrape off extra solder or epoxy from the blade side of your guard (or your handle slab, if no guard). There are lots of ways to do this. This is my way. It is not necessarily the best way.
Take a handy length of aluminum angle "iron".
Hold it against your grinder so the end looks like a "V".
Now raise it to a forty-five degree angle (end still looks like a "V"). Start the grinder.
You'll be grinding off the top two points of the "V".
Hold the angle "iron" at the same angle, slowly pushing
the aluminum into the grinding belt. Keep grinding until the bottom of the "V" is ground. So now everything's at a 45 degree angle.
The point is fairly sharp. Aluminum is softer than steel so it won't scratch the blade & if your gentle, it won't scratch your guard or handle slab.
Good luck! Be sure to use common sense and always be very safe and cautious! Remember: you only get two eyes, two ears, two lungs and ten fingers. Try to make them last at least 100 years.
Cheers, Paul
Take a handy length of aluminum angle "iron".
Hold it against your grinder so the end looks like a "V".
Now raise it to a forty-five degree angle (end still looks like a "V"). Start the grinder.
You'll be grinding off the top two points of the "V".
Hold the angle "iron" at the same angle, slowly pushing
the aluminum into the grinding belt. Keep grinding until the bottom of the "V" is ground. So now everything's at a 45 degree angle.
The point is fairly sharp. Aluminum is softer than steel so it won't scratch the blade & if your gentle, it won't scratch your guard or handle slab.
Good luck! Be sure to use common sense and always be very safe and cautious! Remember: you only get two eyes, two ears, two lungs and ten fingers. Try to make them last at least 100 years.
Cheers, Paul
Replies to This Discussion
-
Permalink Reply by Davin Kates on
-
Thanks for the tip.I'll try it tomorrow.Davin
-
-
KnifeMakerPermalink Reply by CaptJeff Saylor on -
thanks for the tip Paul. Keep them coming!
-
-
Permalink Reply by Daniel Howland on
-
Great tip! thanks!
I clean up the epoxy before it dried, I use wd-40 and q-tips.
I will try this method on solder cleanup.
Dan -
-
Permalink Reply by Eugene Coates Smith Jr on
-
Hey Paul...what a great idea..thanks for sharing!
Gene -
-
-
Hey Paul..saw an article about u in the latest edition of Blade mag...way to go buddy!
-
whiteriverknives.com
Latest Activity
KnifeMakerAndy Larrison replied to Dennis Hibar's discussion A new iKC calendar and a new year of knives!
"I used this knife to process a deer two years ago, just as an experiment to see if it was still useful. It is."
© 2025 Created by Jan Carter.
Powered by
