Replies to This Discussion

Permalink Reply by Ms Data on March 25, 2014 at 21:03

Wouold that be a key fob for your Dodge Viper???

J.J. Smith III said:

Careful if you start.  It can get addictive.  When you start accumulating scraps, you'll start looking for other projects, like key fobs...

• ▶ Reply

Permalink Reply by J.J. Smith III on March 25, 2014 at 21:15

Viper alarm system.  Don't think I'd fit too well in a Viper.  Lol

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 0:36

Like I said earlier, give a piece of one of the inner strands of paracord.  As long as the lanyard hole is big enough to start with, it should pull through.

• ▶ Reply

Permalink Reply by Ron Cooper on March 26, 2014 at 0:40

J.J. had already mentioned using one or two inner strands of paracord to pull the loop through with. That's what I usually do. But, if you don't have an extra piece to harvest those strands from, you can always use mono-filament fishing line, or a piece of string. Sometimes, though, ya just have to admit that it ain't gonna fit, no way no how!

Good luck, my friend! 

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 0:51

Might need to pull a piece of paracord through and tie the lanyard while its on the knife.  OR like Ron and I said before, take the inner strands out and just use the cover.

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 1:04

What kind of damage do you have on the lanyard hole?
l.lantz said:

what is the best way to get the pre made lanyard through the danged lanyard hole? i tried dental floss but it kept breaking and fear that using wire would scratch my knife.and ideas?

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 11:26

"danged". Guess I really should my good reading glasses.

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 11:28

You know, you can check at the local hardware store for something other than paracord to make a lanyard with.

• ▶ Reply

Permalink Reply by Ken Spielvogel on March 26, 2014 at 12:03

Thanks JJ - I'll check for something else.

• ▶ Reply

Permalink Reply by J.J. Smith III on March 26, 2014 at 19:43

Ken, the cross lanyard I did on my 2011 club knife was made from something different. Try some venetian blind cord.

• ▶ Reply

Permalink Reply by Tobias Gibson on April 2, 2014 at 18:17

Funny this topic should come up I did a video on it a few days back:

• ▶ Reply

Permalink Reply by Ken Spielvogel on April 2, 2014 at 18:23

Thanks Tobias, I saw your video and enjoyed it.

• ▶ Reply

▶ Reply to Discussion

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page