iKnife Collector
The online community of knife collectors, A Knife Family Forged in Steel
Wire Inlays on Knife Handles
I just rehandled a multi-blade pocket knife and would like to add some brass wire inlays to the wood scales. I want to use brass wire to match the brass pins. I've tried a few practice cuts in some pine, but it appears that the wood is so soft that the cutting tool just tears through it when I'm cutting across the grain, instead of making a clean-cut channel for the wire. Does anyone know where I can find a tutorial on wire inlays? (I found a printed one, but it doesn't address this problem.) Thanks in advance for any help you can give me.
Replies to This Discussion
-
KnifeMakerPermalink Reply by Stefan Diedericks on -
Terry, check out these 2 links to Blades Magazine.
http://www.blademag.com/article/silverwireinlaypartone
http://www.blademag.com/article/silverwireinlayparttwo/
Blade Magazine also printed this article in their October or November '09 issues. I'm not sure if the content was the same, but I will check it up. -
-
Permalink Reply by Terry Waldele on
-
Stefan, thanks for the information. I went to the Blade Magazine website and read the articles. They are very instructive and I learned a lot from them. Thanks again.
-
White River Knives
Latest Activity
Featureddead_left_knife_guy replied to Doug Ritter's discussion Knife Rights: North Carolina House Passes Concealed Knife Carry Bill
Featureddead_left_knife_guy replied to Ugly Old Guy's discussion My Newest Buck in the group BUCK KNIVES GROUP
© 2025 Created by Jan Carter.
Powered by
