Replies to This Discussion

Permalink Reply by Lewis E.Ward on October 8, 2020 at 10:54

OK, I'll finish up the buzzard that was languishing for years.

• ▶ Reply

Permalink Reply by J.J. Smith III on October 8, 2020 at 14:32

• ▶ Reply

Permalink Reply by Jan Carter on October 8, 2020 at 14:39

LOL sounds like a plan!
Lewis E.Ward said:

OK, I'll finish up the buzzard that was languishing for years.

• ▶ Reply

Permalink Reply by Jan Carter on October 8, 2020 at 14:40

Are you carving that pumplkin or just stabbing him :)

.J. Smith III said:

• ▶ Reply

Permalink Reply by J.J. Smith III on October 8, 2020 at 20:55

Perhaps...

• ▶ Reply

KnifeMakerPermalink Reply by Andy Larrison on October 19, 2020 at 12:22

• ▶ Reply

Permalink Reply by Jan Carter on October 19, 2020 at 14:08

ANDY!  I LOVE IT

• ▶ Reply

Permalink Reply by Bryan Baltz on October 30, 2020 at 16:56

Went with a simple classic Jack O Lantern using my GEC Viper

• ▶ Reply

FeaturedPermalink Reply by dead_left_knife_guy on October 31, 2020 at 16:56

Here's a start...  (Carved using the Victorinox 5" Chef Knife & the Spyderco ClipiTool 2)

• ▶ Reply

FeaturedPermalink Reply by dead_left_knife_guy on October 31, 2020 at 17:00

trying to remove this comment -- sorry it's still here...

• ▶ Reply

FeaturedPermalink Reply by dead_left_knife_guy on October 31, 2020 at 17:06

2nd oops

• ▶ Reply

FeaturedPermalink Reply by dead_left_knife_guy on October 31, 2020 at 17:10

I apologize for the multiple posts -- I was trying to change this one to my official contest entry.  This little guy, carved with the 5" Chef Knife by Victorinox that it's clutching in it's intimidatingly sharp teeth...  How many will be in tact before we light them tonight?  Only time (& the neighborhood squirrels) will tell...

• ▶ Reply

▶ Reply to Discussion

• ‹ Previous
• 1
• 2
• Next ›
• Page