Welcome Home...THANK YOU FOR BEING A PART OF OUR COMMUNITY

A while back a gentleman sent me a large ball bearing wanting a Bowie forged from it.  I started out by welding a little piece of rebar on the bearing to give something to hold on to while it was being forged.

The next step was to forge the bearing into a flat bar.  I used a forging press for this as 52100 steel is quite stubborn under a hammer.

The bar was then forged to shape.  In this case, a narrow tang Bowie.

After normalization the blade was left to cool then ground to inspect for defects and prep for heat treat.


After quenching the blade was tempered then cleaned up and sanded down to 220 grit.  With the blade polished up somewhat it was given a soft back draw.  This is sometimes called "Blue backing".  Doing this further reduces the hardness of the spine but leaves the edge hard.

The blade was polished and a guard fit.  Threads were brazed onto the tang and a nut on the pommel.  The handle of stabilized elk antler was fitted onto the tang.

The handle is bedded with epoxy and the pommel torqued down never to come off again.

The blade is finished with the fixtures blended and the handle sanded and polished.

No knife is complete without a way to carry it.

Views: 31

Reply to This

Replies to This Discussion

Outstanding!  Thanks for sharing the step by step pics.  Very cool.

Reply to Discussion

RSS

White River Knives

Latest Activity

Kevin D commented on Mike Bryant's photo
2 hours ago
Kevin D commented on Mike Bryant's photo
2 hours ago
Kevin D posted a photo
3 hours ago
Kevin D added a discussion to the group Knife Repair, Modification, Restoration & Improvement
4 hours ago
Kevin D replied to Lars Ray's discussion CFK / iPAK Knives - for all those who dare! in the group BOX FULL OF KNIVES
5 hours ago
Kevin D commented on dead_left_knife_guy's group The Kukri (Khukuri) Group
5 hours ago
Carl Bradshaw commented on Jan Carter's group Daniels Family Knife Brands
yesterday
Carl Bradshaw commented on Jan Carter's group Daniels Family Knife Brands
yesterday
Kevin D commented on Lars Ray's photo
yesterday
Kevin D replied to daniel diaz's discussion one piece fighter brass SEA WOLF KNIFE CO. U.S.A. Gus Marsh
yesterday
daniel diaz replied to daniel diaz's discussion one piece fighter brass SEA WOLF KNIFE CO. U.S.A. Gus Marsh
yesterday
Randy, HHH Knives commented on Fred Feightner's group Case Fans
yesterday
Kevin D replied to daniel diaz's discussion one piece fighter brass SEA WOLF KNIFE CO. U.S.A. Gus Marsh
yesterday
daniel diaz posted a discussion
yesterday
Kevin D commented on Fred Feightner's group Case Fans
yesterday
daniel diaz replied to Mike El's discussion Rare Sea Wolf UDT Knife made by Gus Marsh
Thursday

© 2025   Created by Jan Carter.   Powered by

Badges  |  Report an Issue  |  Terms of Service